Installation
 
Tools Needed: 

Drill 
4 mm Drill Bit 
Tape Measure 
Level 
Screw Driver 
Beer 

Steps: 

• Choose the wall location and height that you’d like your snowboard to be at. (The board should rest near the top inserts) 
• Measure the width of your snowboard at the top inserts 
• Using the measurement from above, mark the two pilot holes with a pencil   
• Use a level to ensure the mounting holes are even
• Drill your pilot holes 
• Insert the drywall anchor into the pilot holes 
• Hand screw each wall mount into place 
• Load your board by inserting it at the narrowest point and gently slide into place
• If needed, loosen the screws to adjust the width of the hangers based on where you want your board to rest 
• Place the rubber cover onto the hanger
• Step back and admire your beautiful snowboard display

Show off your entire snowboard collection with Union's wall mount snowboard holders. These easy-to-install snowboard holders will help you get your boards out of that stack in the closet and on display for everyone to see.